3
Blue LED is
not lit (AC
Operation).
Blue LED is
not lit (Battery
Operation).
No sound
is coming
from speakers.
The voice of
the person on
the other end
of the phone
line cannot be
heard through
the speakers.
The power supply isn’t connected to a wall
outlet and/or the power supply connector is not
plugged into the DC connector on the back of
the inMotion iMT1.
The surge protector (if used) isn’t powered on.
The wall outlet is not functioning.
The power isn’t turned on.
No batteries are installed.
The power isn’t turned on.
The volume is set too low.
The Palm device is not correctly seated onto the
docking connector.
The Palm device is properly docked and the
inMotion iMT1’s blue LED is lit, but the Palm
device is in the “mute” mode.
If using an alternate audio source, the audio
source is not properly connected to the
inMotion iMT1 or there is a problem with the
alternate audio source.
The inMotion iMT1 is not in phone mode.
Insert the barrel connector from the power supply into the DC
connector on the back of the inMotion iMT1. After this connection
is made, insert the power supply into a wall outlet.
If the power supply is plugged into a surge protector, make sure the
surge protector is switched on.
Plug another device into the same wall outlet to confirm the outlet
is working.
Turn on the inMotion iMT1 by pushing the power button located on
the top of the unit. A blue LED will light around the button when
the power is on.
Install four AA batteries (not included) into the battery
compartments on the bottom of the inMotion iMT1 (two to each
compartment). Make sure the batteries are installed as illustrated
in the battery compartments.
Turn on the inMotion iMT1 by pushing the power button located on
the top of the unit. A blue LED will light around the button when
the power is on.
The “+” and “–” buttons on the top of the inMotion iMT1 are the
master volume controls. Press and hold the “+” button to increase
the volume.
Remove the Palm device and re-seat it in the docking station.
Turn off the “mute” function on the Palm device.
Connect an alternate audio source — such as a CD player, MP3 player,
or portable DVD player — to your inMotion iMT1 by plugging one
end of the 3.5mm stereo cable to the line out of your portable
device (if it has one) or to the device’s headphone jack. Connect
the other end to the input marked “AUX” on the back of the
inMotion iMT1.
Ensure that the inMotion iMT1 is in phone mode by pushing the
mode button until the green LED with the phone icon turns on.
Troubleshooting
Symptom Possible Problem Solution
(16 pages)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Commentaires sur ces manuels